Technical Data for SpeedVac

DOWNLOAD THE DIMENSIONAL DATA PDF HERE

Speedvac™ Specifications
Recommended Usage: Dry Pick-up/Blow Gun
Operating psi Range: 80-120 psi
Noise Level: 80 dBA
Vacuum Capabilities 2.5 HG @ 80 psi
Gallon of Water Pick-up/Min. Floor Spills
Range of Pick-up Materials Dry Material to Wet Chips
Throat Size/Diameter 1"
Air Consumption 18 cfm @ 80 ps

SpeedVac™ Diagram

Operating Instructions

  • A 1/4” threaded input is provided in the handle of the speed vac. A hand tightened air line connection should be sufficient to provide leak free operation. Care should be taken not to over tighten the connection and result in cracking the housing.
  • Dual operation as a blow gun or hand held vacuum is possible by removing and reversing the cylinder located in the barrel of the unit. To remove the cylinder from the barrel section, turn the knurled and threaded rear section of the barrel in a counter clockwise direction and remove it. Pull the cylinder out, along with the O Ring. The arrow on the side of the cylinder indicates the air flow.
  • Return the cylinder with the arrow pointing forward for a blow gun application or with the arrow pointing to the rear for a vacuum operation. Return the O Ring and knurled cap to a hand tightened positiion.

Maintenance and Cleaning

Compact, light weight, and low cost, the Speed Vac is the smart clean up tool. There’s no electric motor, no clumsy canister to empty, no moving parts. Powered by ordinary compressed air, it can vacuum wet chips or dry matter directly into an open drum. It switches from vacuum to blow mode with a simple reverse of the air chamber. The trigger switch is used for on/off.

CAUTION:

BEFORE OPERATING THE SPEEDVAC MODEL 90400 IN THE VACUUM MODE, A HOSE OR DUST BAG MUST BE ATTACHED TO THE REAR OF THE UNIT. OPERATORS SHOULD WEAR SAFETY GLASSES WHEN USING THE SPEED VAC.